Thundermax Map Development - Proper Steps Manual de usuario descargar pdf

How to Develop Your Map

The ThunderMax Module has been engineered to make the required adjustments to “Fine-Tune” the

running conditions of your engine based on a collection of readings it gathers while you are riding

your motorcycle.

Follow the steps below to ‘develop’ your map based on your specific motorcycle:

1. Following the link below and choose the map that is ‘Closest’ to your combination.

Maps-How to Select and Load From Software Data Base

Selecting Data Base Map

2. After you have successfully written the desired map to your module, you need to ride the

motorcycle specifically to create “learned points” in your map.

(This is best done repeatedly accelerating up long hills if possible.)

3. After completing a Riding Session*(See Below), perform the AutoMap function located

under the Map Editing tab.

This will save the “learned points” to your module and allow you to create more learned points

with each AutoMap session.

After a few of these sessions, your module should be to the point where it will be making very

few, small corrections and your map will be ‘Developed’.

1 2

How to Develop Your Map The ThunderMax Module has been engineered to make the required adjustments to “Fine-Tune” the running conditions of your

*Riding Session After the engine is at normal operating temperature, ride the motorcycle using "smoothly varied" throttle and rpm conditi

Sin comentarios

Thundermax Map Development - Proper Steps Manual de usuario