Thundermax PN#309-362 - FL Touring Models Manual de usuario descargar pdf

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 TmaxSupport@Thunder-Max.com

#309-362, 2010-13 TBW Touring Models

Thank you for purchasing a ThunderMax ECM!

Please read through the following instructions

before beginning the installation procedure.

Following these instructions will ensure that the ECM is

installed and setup properly for optimal results. If you

have any problems or questions, please refer to the

TMax Tuner .pdf Manual, included on the CD (Help

Menu) with this package. Record serial number NOW

on your warranty card, and below for your records!

Serial # TMWM___________________

Step 1: 1: Insert the TMax

Tuner CD into your

computer. TMax Tuner will

automatically open the

InstallShield Wizard when

the computer finds the CD-

Rom. Follow the

instructions and install the

software on your computer.

After installing and opening the software the first time,

you will be prompted to install the driver for the USB

connection (see page 4). The TMax Tuner software

package is designed to run on personal computers using

Microsoft® Windows 2000™, Windows XP™, Windows

Vista™ and Windows 7 & 8 operating systems. The

computer system must have an adequate amount of free

space on the hard drive for proper operation. TMax

Tuner is approximately 140MB when installed. TMax

Tuner is not supported by any other operating systems.

Step 2 : Module Installation - Touring Models

FL-A: Install the ThunderMax ECM. Remove seat and

both side covers. Push up on the bottom of the fuse box

cover to remove the cover (located on the left side of the

bike), then remove the ECM fuse from the fuse box.

FL-B: Remove the stock narrow band sensors from the

exhaust pipe. Special Note – If you have previously

installed another tuning device such as a Power

Commander, be sure to remove the device and any

“O

Sensor Eliminators” that may have been

installed at the sensor harness plugs at that time!

2008-2009 models: 18mm sensors are located at the

top of the head pipe; supplied 18mm wide-band sensors

will replace the stock narrow band sensors. Some stock

2008 model rear bung location may cause interference

with the transmission lid when using the longer

ThunderMax oxygen sensor. If this is the case, crease

the pipe next to the bung to change the angle of the

sensor for clearance, or relocate the bung for proper

clearance. DO NOT pull or pry on the sensor to gain

clearance—the sensor will be damaged if you do!

2010-13 models: If retaining factory catalyst-equipped

headpipes, 18mm bungs will need to be added to the

headpipes. Bungs should be located no more than 3-4”

from the head pipe connection (for ideal location, refer to

the factory location on 2009 models). Weld-in bungs are

available from many

sources in straight or

angled designs. See

Video on adding new

bungs on the web at

YouTube.com

(search

ThunderMaxAV) or

through your smart

phone by scanning

the QR code on page

Stock 2010-2013

12mm O

sensors are located downstream on the

factory header pipes, between the engine and

transmission; unplug and remove them as they will

affect your ThunderMax system performance if left

plugged in. Stock sensor connectors are located under

the bike's right side cover (black and gray plugs). 12 mm

pipe bung O

caps are available from many sources.

FL-C: Install supplied wide-band sensors into the pipes;

route the front sensor along the cross brace on the

frame in front of the engine and down the lower frame

rail on the right side of the motorcycle.

Installation / Setup Guide

Please Note: This product is Legal in California

only for racing vehicles which may never be used

upon a highway. The user shall determine suitability of the

product for his or her use. Installation and use on a pollution-

controlled vehicle constitutes tampering under the U.S. EPA

guidelines and can lead to substantial fines. Review your

application and check your local laws before installing.

New! Video Instructions Now Available on You Tube – Smart Phone Users See Back Page

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Installation / Setup Guide

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 1 #309-362, 2010-13 TBW Touring Models Thank

Pagina 2

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 2 FL-D:. Route the rear sensor lead between

Pagina 3

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 3 ECM. Before installing connector, light

Pagina 4

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 4 If you purchased a pre-mapped syst

Pagina 5

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 5 Duals). Choosing the closest style wil

Pagina 6

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 6 Step 5: Next, go to the [Tuning Maps] Tree an

Pagina 7 - TIPS AND GENERAL INFORMATION

www.Thunder-Max.com Installation / Setup Guide V2013.10.15 [email protected] 7 TIPS AND GENERAL INFORMATION Several support features

Pagina 8 -

www.Thunder-Max.com 309-362 Installation / Setup Guide V2013.10.15 [email protected] 8 For additional information, scan the QR-codes

Modelos relacionados PN#309-464 XR1200 | PN#309-361 Cable Throttle |

Mas documentos para Para Motocicletas Thundermax PN#309-362 - FL Touring Models

a Ver el documento Thundermax PN#309-362 - FL Touring Models Manual de usuario

Thundermax PN#309-362 - FL Touring Models Manual de usuario (-1 paginas)

Comentarios a estos manuales

Sin comentarios

Thundermax PN#309-362 - FL Touring Models Manual de usuario

Busca en linea o descarga Manual de usuario para Para Motocicletas Thundermax PN#309-362 - FL Touring Models. ThunderMax PN#309-362 - FL Touring Models User Manual Manual de usuario

Indice de contenidos

Modelos relacionados PN#309-464 XR1200 | PN#309-361 Cable Throttle |

Mas documentos para Para Motocicletas Thundermax PN#309-362 - FL Touring Models

Comentarios a estos manuales

Relacionado con productos y manuales para Para Motocicletas Thundermax PN#309-362 - FL Touring Models